![]() ![]() fixes not working Ghost on F4xx ( #12809) by in #12811.If CS is asserted between transfers then consider bus to be busy for … by in #12784.Converge IMU faster at higher groundspeed during GPS Rescue by in #12785.Fix bootloader jump for g4 mcu ( #12675) by in #12783.Remove 15 m/s limit on estimated vario by in #12788. ![]() Tri-state USART TX output if load due to powered down peripheral is d… by in #12782.DSHOT timing improvements by in #12709.Fix buffer overflow in JETIEXBUS character reception ( #13130) by in #13136.Disable ICM4268xx AFSR feature to prevent stalls by in #13137.Check tx on MSP and GPS only by in #13113.Remove dshot_telemetry_start_margin setting to use auto-tune( #13075) by in #13082.Allow for F7 UART idle preamble to be sent on startup - 4.4-maintenance by in #13022.4.4 maintenance uart enable/disable f4 by in #13020.Enable/disable the UART TX before changing the TX pin mode by in #13018.Add dshot_telemetry_start_margin setting ( #12912) by in #12964.Call updateInit() before writing motor command data by in #12866.Add support for MSP2_SENSOR_GPS message from RemoteID module by in #13081.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |